House Woodworking and Gardening Family: Lets make a thumb chair

There are several woodworking sites that I follow on Facebook and one of them is Ana Whites. She runs a DIY blog and gives out plenty of free plans that she sketches. A couple of weeks ago she posted a plan for a thumb chair that you can find HERE. Once I saw it I knew that it would be perfect for my two boys. It can be made out of 1x3s and some 1x12. My local Home Depot never has flat 1x12s so I picked up some 1x6s and will be gluing them up for the seat bottom & back.

This is the example from her blog.

I set the angle for 10 degrees

and the bevel for 5 degrees

Here is the mitre saw all set up and ready to cut

I am making 2 chairs and I set up a stop block to make sure all the

legs are the same length. I almost reset the saw to the other side to cut the other

half of the legs when I realized that you can flip and then turn them over to get the

opposite side.

Make sure that the bevel leans into the center of the chair when you

connect the pieces.

I drilled pockety holes into the cross pieces for the legs and the stretchers

that connect the two leg assemblies.

This Kreg clamp is a life saver. I have a real problem with the wood shifting

when I drill in the pockets holes and making the pieces uneven.

It wasnt in the plans but I used a 1/4" roundover bit on my router table

to ease over the sides of the legs and bottom of the crosspieces. I left the top
and bottoms flat. The top of the legs is at a 5 degree bevel but the crosspiece
is not so I had to be careful when I attached them to keep the high point to

the outside.